Sagem F@st 244x Guía de instalación descargar pdf (Pagina 225)

Annex A - Troubleshooting

SAGEM F@st™ 240x/244x Reference Manual - 288097371-02

Sagem Communication document. Reproduction and disclosure prohibited Page A-9

A.6 Reinitialising your router

To reinitialise your router, click button "Reboot" at the top right of the welcome page of your

HTTP configurator. When you click this button all the LEDs go off, except for the green "

LED (WLAN) (if the wireless network is activated); the green "

" LED (PWR) then lights, and

the initialisation process starts. It lasts for around a minute.

Note : The green "

" (ADSL) and " (LAN) LEDs light if they are connected.

The "

@" LED (Internet) lights in green if "PPP" link is established.

A.7 Re-establishing the factory configuration

To undertake the procedure, there are two possibilities:

1) Using the HTTP configurator

• In the welcome screen of your HTTP configurator, select the heading Management

followed by the sub-menu Restore Default in the Settings menu (cf. § 6.11.1.3).

2) Using the "REG" button

• press the REG pushbutton for at least 15 seconds; all the LEDs go off except for the green

" LED (WLAN) (if the wired network is activated); the green " " LED (PWR) then all the

LEDs and the process for returning to the factory configuration starts. It lasts for around

2 minutes.

This operation deletes the entire personalised configuration of your

router: Password, Configuration, etc.

After a return to factory configuration, it is necessary to install your router again

using the installation CD-ROM, or to enter again the ADSL connection data supplied

by your Internet Service Provider (ISP) (cf. Internet Connection section - § 6.6).

1 2 ... 220 221 222 223 224 225 226 227 228 229 230 ... 253 254

Sin comentarios

Sagem F@st 244x Guía de instalación Pagina 225