Sagem 2604 Guía de instalación Pagina 203

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 232
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 202
Annex A - Troubleshooting
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Sagem Communications document. Reproduction and disclosure prohibited Page A-7
A.5 Interpreting the LEDs
A.5.1 The "ADSL" LED blinks slowly
¾ Check the connection of your ADSL filters. Each telephone socket of your installation which
is used must be equipped with an ADSL filter.
¾ Check that the RJ11 type line cord delivered with your router is connected to one of your
sockets. It is recommended that no telephone extension is used.
¾ Finally, check with your ISP on the availability of the ADSL service on your telephone line.
A.5.2 "Wi-Fi" LED off
If this LED is off, this indicates that the WLAN interface of the router is not active.
To activate the wireless network, check the box "Enable Wireless" in the "Basic" menu of the
"Wireless" heading of the HTTP configurator (see sub-section 5.7.1).
A.5.3 All LEDs are off
¾ Check that the type of power available in your premises is compatible with the mains
voltage required for powering your router.
¾ Check that the delivered power cord is properly connected at one end to the mains power
network.
¾ Check that the power connector is inserted correctly in the corresponding connector (power)
of the router.
Vista de pagina 202
1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 231 232

Comentarios a estos manuales

Sin comentarios