Sagem SAGEMFAST 1500WG Guía de instalación descargar pdf (Pagina 27)

Troubleshooting 26

SAGEM F@st™ 1500 / 1500WG

TROUBLESHOOTING

Absence of ADSL synchronization

Access to the HTTP configurator is impossible

The ADSL LED does not come on or is flashing.

• Check that the modem/router is powered up. The PWR LED should be on. If that is not

the case:

- Check that the power pack is properly connected to the mains. If it is connected to a

multiple socket block, check that this is powered up.

- Check that the power pack cable is properly connected to the modem/router.

- Check that the pushbutton is in "depressed" position.

• Check that the ADSL cable is properly connected to your telephone socket, to the

ADSL port of the modem/router.

• Check that all the ADSL filters are properly connected to each of your telephone

sockets.

If the problem persists, consult your Internet Service Provider.

All your telephone installation sockets must be fitted with an ADSL filter.

• Open your usual Web browser.

• In the Address field, type the modem/router's IP address:

http://192.168.2.1.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 37 38

Sin comentarios

Sagem SAGEMFAST 1500WG Guía de instalación Pagina 27