Sagem 4450E Manual de instalación Pagina 93

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 198
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 92
SAGEM 3P@C
3P@C Installation Manual
Page 4-32 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
Figure 4-44 Install a dummy panel
Place the dummy
panel in the blank slot
Screw the screw into
the screw hole
Tighten the upper
and lower screws
Side face
Front face
prompt
The width of the dummy panel in the slot of the SMUB is
greater than the width of the dummy panel in the slot of the
subscriber service board. The dummy panel in the slot of the
subscriber service board is fixed by 2 screws, while that in
the slot of the SMUB is fixed by 4 screws.
4.7.
4.7.4.7.
4.7. Connecting the Subscriber Cables
The rear leading-out mode is adopted for the ADSL/VDSL subscriber cables of 3P@C 4450E. The special-
purpose 3*8 cable connectors are used to connect with the DIN connectors on the rear panel. The subscriber
cables are divided into two types: LU connection subscriber cables and LC connection telephone switch cables.
The connector of the LU subscriber cable has 3 marks: UP X1, UP X2 and UP X3, which are connected on the
DIN connector on the backplane from the top down in the sequence of UP X1, UP X2 and UP X3. The connector
of the LC telephone switch cable has 3 marks: DOWN X1, DOWN X2 and DOWN X3, which are connected to
the DIN connectors in the lower row on the backplane from the top down in the sequence of DOWN X3, DOWN
X2 and DOWN X1. LU and LC subscriber cables are installed on the DIN connectors on the backplane (as
shown in Figure 4-45). The pinouts of the LU subscriber cable are shown in Figure 4-46 and Table 4-3, while the
pinouts of the LC telephone switch cable are shown in Figure 4-47 and Table 4-4.
prompt
The connector of the LU subscriber cable is plugged from
the upper part of the connector in the upper row, while the
connector of the LC subscriber cable is plugged from the
lower part of the connector in the lower row.
Vista de pagina 92
1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 197 198

Comentarios a estos manuales

Sin comentarios