Sagem 4450E Manual de instalación Pagina 110

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 198
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 109
SAGEM 3P@C
3P@C Installation Manual
Page 6-3 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
6.2.2.
6.2.2.6.2.2.
6.2.2. Remote Configuration via Telnet
3P@C 4450E supports the Telnet remote management. The 10/100M interface on the SMUB of 3P@C 4450E
can be connected to the LAN, and you may log in to 3P@C 4450E by Telnet remotely through the computer in
the LAN, thus implementing remote configuration management. The connection diagram is shown in Figure 6-1.
Figure 6-1 Remote management of 3P@C 4450E via Telnet
To implement remote management of Telnet, take the following steps:
Step 1 Enter the command line management system 3P@COS via
the Console interface, and enter the Configuration Mode
according to the method mentioned above.
Step 2 Set IP address for 3P@C 4450E.
The 3P@C 4450E switch has a default VLAN named “default”.
Set an IP address for the VLAN. This IP address will serve as
the ID of the 3P@C 4450E in the network.
3P@C(config)# config vlan default ipaddress 10.10.10.1/24
Step 3 Log in to the 3P@C 4450E by Telnet from the computer.
telnet 10.10.10.1
Then input the user name (“admin” by default) and password
(“3P@C” by default) and you can log in successfully.
Vista de pagina 109
1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 197 198

Comentarios a estos manuales

Sin comentarios