Sagem 4450E Manual de instalación Pagina 68

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 198
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 67
SAGEM 3P@C
3P@C Installation Manual
Page 4-7 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
Figure 4-8 The connecting boards before combining two cabinets side by side
Figure 4-9 The connecting boards after combining two cabinets side by side
Figure 4-10 Effect after the installation of two combined cabinets
1.1.1.40
1.1.1.401.1.1.40
1.1.1.40 Insulation test
Set the multimeter to the resistor range to measure the resistance between the bolt of the pressure plate
assembly and the cabinet. If the circuit is disconnected, end the installation. Otherwise, it indicates the cabinet is
not insulated from the supports. In this case, remove all the pressure plate assemblies to check if any insulation
sleeves or pads of the supports are missing or any insulation parts are damaged. Then install the pressure plate
assemblies again and repeat the insulation test.
Vista de pagina 67
1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 197 198

Comentarios a estos manuales

Sin comentarios